Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ref:tools124 [2021/11/12 23:18] hippysmack [Ironhead Engine] |
techtalk:ref:tools124 [2021/11/12 23:24] hippysmack [Ironhead Engine] |
||
---|---|---|---|
Line 11: | Line 11: | ||
|1/2" wrench cut down (box also ground down to fit \\ confined areas) 3/4" socket notched with an angle \\ grinder. ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=2))|Torque wrench extender welded and ready to use. \\ Extension Length: 3" from the center of the drive \\ square to the center of the (intended) bolt. ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=2))|Torquing rear rocker box bolts with torque wrench \\ extender. ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=2))| | |1/2" wrench cut down (box also ground down to fit \\ confined areas) 3/4" socket notched with an angle \\ grinder. ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=2))|Torque wrench extender welded and ready to use. \\ Extension Length: 3" from the center of the drive \\ square to the center of the (intended) bolt. ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=2))|Torquing rear rocker box bolts with torque wrench \\ extender. ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=2))| | ||
- | |{{techtalk:ref:tools:torque_wrench_extension_4_by_hopper.jpg?direct&400|}}|{{techtalk:ref:tools:torque_wrench_extension_3_by_hopper.jpg?direct&300|}}| | + | |{{techtalk:ref:tools:torque_wrench_extension_4_by_hopper.jpg?direct&300|}}|{{techtalk:ref:tools:torque_wrench_extension_3_by_hopper.jpg?direct&300|}}|{{:techtalk:ref:tools:torque_with_a_crows_foot.jpg?direct&300|}}| |
- | ^ A little cutting, a little welding and you have a special wrench to reach the bolts under the frame. ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=2)) ^^ | + | ^ A little cutting, a little welding and you have a special wrench to reach the bolts under the frame. ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=2)) ^^ T recalculate or not. ((photo by Hippysmack)) ^ |
====== Evo Engine ====== | ====== Evo Engine ====== | ||
Cutting down Allen wrenches to make them shorter on the end will allow you to get into tight places easier. \\ | Cutting down Allen wrenches to make them shorter on the end will allow you to get into tight places easier. \\ |