Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ref:tools124 [2019/08/17 14:47] hippysmack [Evo Engine] |
techtalk:ref:tools124 [2021/11/12 21:53] hippysmack [Evo Engine] |
||
---|---|---|---|
Line 19: | Line 19: | ||
|{{techtalk:ref:tools:cut_down_allen_1_wrenches_by_hippysmack.jpg?direct&400|}}|{{techtalk:ref:tools:cut_down_allen_3_wrenches_by_hippysmack.jpg?direct&400|}}| | |{{techtalk:ref:tools:cut_down_allen_1_wrenches_by_hippysmack.jpg?direct&400|}}|{{techtalk:ref:tools:cut_down_allen_3_wrenches_by_hippysmack.jpg?direct&400|}}| | ||
^ Allen wrench end cut shorter with a Dremil cut-off blade ((photos by Hippysmack)) ^^ | ^ Allen wrench end cut shorter with a Dremil cut-off blade ((photos by Hippysmack)) ^^ | ||
+ | |||
+ | You can also use a 1/4" ratcheting wrench with 1/4" attachments (cheap attachments are easy to replace). \\ | ||
+ | It's easier to get at Allen heads such as the speedo sender and the rear left rocker cover bolts easy to remove/replace. \\ | ||
+ | It's a slimmer profile ratchet that can be useful at times. ((Sportsterpaul of the XLFORUM http://xlforum.net/forums/showthread.php?p=5924506#post5924506)) \\ | ||
+ | This is a 'Snap On Blue Point' brand 1/4" and 5/16" offset/reversible wrench ($32 delivered). \\ | ||
|{{:techtalk:ref:tools:offset_wrench_by_aussiegazza.png?direct&300|}}| | |{{:techtalk:ref:tools:offset_wrench_by_aussiegazza.png?direct&300|}}| | ||
^ Offset wrench for rocker box cover. ((photo by AussieGazza of the XLFORUM http://xlforum.net/forums/showthread.php?postid=1181033)) ^ | ^ Offset wrench for rocker box cover. ((photo by AussieGazza of the XLFORUM http://xlforum.net/forums/showthread.php?postid=1181033)) ^ | ||
+ | |||
+ | A company called KATAR makes a wrench specifically for the Evo lower rocker box bolts. Made in the USA. \\ | ||
+ | It's a reversible ratcheting box wrench with a deep well 7/16" socket. \\ | ||
+ | This allows for removal or installation of the lower rocker box hex nut bolts. \\ | ||
+ | It has a long handle and a short profile making it easier to get to the bolts. \\ | ||
+ | However, it's best to only install the bolts to snug, then use a 1/4" beam type torque wrench to finish bolt installation. \\ | ||
====== Rocker Arms ====== | ====== Rocker Arms ====== |