Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ref:tools129 [2018/08/25 16:34] hippysmack |
techtalk:ref:tools129 [2019/04/08 21:16] hippysmack [Flexible Extension for Dual Plug Heads] |
||
---|---|---|---|
Line 9: | Line 9: | ||
^ Homemade Spark Plug Gapping Tool ((photo by Deep Diver of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=5)) ^ | ^ Homemade Spark Plug Gapping Tool ((photo by Deep Diver of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=5)) ^ | ||
- | ===== Spark Plug Hole Adapters for Diagnostic Testing ===== | + | ===== Flexible Extension for Dual Plug Heads ===== |
+ | Care should be taken when installing the top spark plug on S models or any with dual plug heads. \\ | ||
+ | It's easy to get into the wrong position and break the end of the plug with a conventional wrench. \\ | ||
- | |{{:techtalk:ref:tools:homemade_12mm-to_quarter_npt_hose_adapter_1_by_cjburr.jpg?direct&300|}}|{{:techtalk:ref:tools:homemade_12mm-to_quarter_npt_hose_adapter_2_by_cjburr.jpg?direct&300|}}| | ||
- | |{{:techtalk:ref:tools:homemade_12mm-to_quarter_npt_hose_adapter_3_by_cjburr.jpg?direct&300|}}|{{:techtalk:ref:tools:homemade_12mm-to_quarter_npt_hose_adapter_4_by_cjburr.jpg?direct&300|}}|{{:techtalk:ref:tools:homemade_12mm-to_quarter_npt_hose_adapter_5_by_cjburr.jpg?direct&300|}}| | + | This flexible extension allows you to maneuver the plug into the hole using the handle on the end to start the threads without much force. \\ |
- | ^ Homemade 1/4" NPT to 12mm Spark Plug Hole Adapter ((photos by cjburr of the XLFORUM http://xlforum.net/forums/showthread.php?t=56497)) ^^^ | + | This was once available at most auto parts stores and is still available online. \\ |
+ | If the plug doesn't thread easily, the grip will slip on the plug instead of forcing the threads together and cross-threading them. \\ | ||
+ | Then you simply back it out, re-position and try again until the threads are started correctly. \\ | ||
+ | Once the threads are started, remove the flex tool, use a conventional plug wrench to snug up and then a torque wrench for final tightening. \\ | ||
+ | |||
+ | | STEELMAN PRO 08310R flexible 12-Inch spark plug starter tool ((photos by Hippysmack)) ||| | ||
+ | |{{:techtalk:ref:tools:flexible_spark_plug_extension_1_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:tools:flexible_spark_plug_extension_2_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:tools:flexible_spark_plug_extension_3_by_hippysmack.jpg?direct&300|}}| | ||
\\ | \\ |