Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ref:tools130 [2019/12/02 01:33] hippysmack |
techtalk:ref:tools130 [2020/06/20 04:27] hippysmack [Brakes: Brake Cylinder Hone] |
||
---|---|---|---|
Line 4: | Line 4: | ||
====== Removal / Installation ====== | ====== Removal / Installation ====== | ||
98 style rear caliper mounting bolts (2) require a Torx T-40 driver bit. \\ | 98 style rear caliper mounting bolts (2) require a Torx T-40 driver bit. \\ | ||
+ | The brake hose is fastened to the swingarm with a P-clamp and a 1/4" hex head screw. | ||
- | {{:techtalk:ref:tools:98_rear_caliper_bolts_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | + | {{:techtalk:ref:tools:98_rear_caliper_bolts_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:ref:tools:98_rear_caliper_hose_tie-clamp_by_hippysmack.jpg?direct&300|}} \\ |
- | ====== Brakes: Brake Cylinder Hone ====== | + | ====== Brake Cylinder Hone ====== |
* This zero-cost brake cylinder hone works better on small motorcycle master cylinders than the proper tool you buy at the auto parts store. It fits inside 13-15 mm master cylinders much easier and does not fly apart and scar up the aluminum cylinder bore. ((Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=5)) | * This zero-cost brake cylinder hone works better on small motorcycle master cylinders than the proper tool you buy at the auto parts store. It fits inside 13-15 mm master cylinders much easier and does not fly apart and scar up the aluminum cylinder bore. ((Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=5)) |