Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
Next revision Both sides next revision
techtalk:ref:tools131 [2018/05/22 16:42]
hippysmack created
techtalk:ref:tools131 [2021/07/22 04:05]
hippysmack [Sprocket Nut Removal]
Line 2: Line 2:
 ====== REF: Tools - 131 ====== ====== REF: Tools - 131 ======
 ====== Trans Final Drive Sprocket Tools ====== ====== Trans Final Drive Sprocket Tools ======
 +
 +====== Sprocket Nut Removal ======
 +Transmission sprocket nut for rigid XLs should all be the same wrench size: 1-7/8" (47.625mm) . \\
 +It's a 6 point nut and will require a 6 point socket to remove / install. \\
 +Normally, the sprocket holding tool below is used to keep the sprocket from turning while removing the nut. \\
 + 
 +{{:​techtalk:​ref:​tools:​transmission_sprocket_removal_with_impact_wrench_by_anachris.jpg?​direct&​300|}} ((photo by AnaChris of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=1725973&​highlight=oil+pump&​page=20)) {{:​techtalk:​ref:​tools:​transmission_sprocket_nut_size_1998_1200s_by_hippysmack.jpg?​direct&​300|}} ((photo by Hippysmack)) \\
 +
 +====== Sprocket Holding Tool ======
 +
 +Final drive locking tool from J&​Pcycles.com part # (910-576). \\
 +Don't forget to buy a longer grade 8 bolt to use as a stop for the tool. \\
 +Just pick the hole your going to use and but one from an auto parts or hardware store. \\
 +
 +{{:​techtalk:​ref:​tools:​trans_sprocket_holding_tool_by_anachris.jpg?​direct&​300|}} ((photo by AnaChris of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=1725973&​highlight=oil+pump&​page=30)) \\
 +
 +===== Fabricated Sprocket Nut Wrench =====
  
 |{{:​techtalk:​ref:​tools:​transmission_sprocket_nut_1_by_krtt_clone.jpg?​direct&​300|}}|{{:​techtalk:​ref:​tools:​transmission_sprocket_nut_2_by_krtt_clone.jpg?​direct&​300|}}| |{{:​techtalk:​ref:​tools:​transmission_sprocket_nut_1_by_krtt_clone.jpg?​direct&​300|}}|{{:​techtalk:​ref:​tools:​transmission_sprocket_nut_2_by_krtt_clone.jpg?​direct&​300|}}|