Table of Contents
This is an old revision of the document!
REF: Tools - 131
Trans Final Drive Sprocket Tools
Sprocket Nut Removal
Transmission sprocket nut for rigid XLs should all be the same wrench size: 1-7/8“ (47.625mm) .
It's a 6 point nut and will require a 6 point socket to remove / install.
Normally, the sprocket holding tool below is used to keep the sprocket from turning while removing the nut.
Sprocket Holding Tool
Final drive locking tool from J&Pcycles.com part # (910-576).
Don't forget to buy a longer grade 8 bolt to use as a stop for the tool.
Just pick the hole your going to use and but one from an auto parts or hardware store.
Fabricated Sprocket Nut Wrench
1)
photo by AnaChris of the XLFORUM http://xlforum.net/forums/showthread.php?t=1725973&highlight=oil+pump&page=20
2)
photo by Hippysmack
3)
photo by AnaChris of the XLFORUM http://xlforum.net/forums/showthread.php?t=1725973&highlight=oil+pump&page=30
4)
, 5)
, 6)
photos by KRTT Clone of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=5