Differences

This shows you the differences between two versions of the page.

--- techtalk:ref:tools131 [2020/05/28 18:58]
hippysmack [Trans Final Drive Sprocket Tools]
+++ techtalk:ref:tools131 [2021/07/22 04:05]
hippysmack [Sprocket Nut Removal]
@@ Line 3: / Line 3: @@
 ====== Trans Final Drive Sprocket Tools ======
-====== Sprocket Tool ======
+====== Sprocket Nut Removal ======
+Transmission sprocket nut for rigid XLs should all be the same wrench size: 1-7/8" (47.625mm) . \\
+It's a 6 point nut and will require a 6 point socket to remove / install. \\
+Normally, the sprocket holding tool below is used to keep the sprocket from turning while removing the nut. \\
+{{:techtalk:ref:tools:transmission_sprocket_removal_with_impact_wrench_by_anachris.jpg?direct&300|}} ((photo by AnaChris of the XLFORUM http://xlforum.net/forums/showthread.php?t=1725973&highlight=oil+pump&page=20)) {{:techtalk:ref:tools:transmission_sprocket_nut_size_1998_1200s_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\
+====== Sprocket Holding Tool ======
+Final drive locking tool from J&Pcycles.com part # (910-576). \\
+Don't forget to buy a longer grade 8 bolt to use as a stop for the tool. \\
+Just pick the hole your going to use and but one from an auto parts or hardware store. \\
 {{:techtalk:ref:tools:trans_sprocket_holding_tool_by_anachris.jpg?direct&300|}} ((photo by AnaChris of the XLFORUM http://xlforum.net/forums/showthread.php?t=1725973&highlight=oil+pump&page=30)) \\

Trace: