Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ref:tools140 [2018/11/01 18:28] hippysmack [Tool Posts / Indicator Holders] |
techtalk:ref:tools140 [2024/01/24 04:08] hippysmack |
||
---|---|---|---|
Line 14: | Line 14: | ||
See below how to [[techtalk:ref:tools140#temporary_backing_plate_mod|temporarily change the backing plate]] on some indicators for this application. \\ | See below how to [[techtalk:ref:tools140#temporary_backing_plate_mod|temporarily change the backing plate]] on some indicators for this application. \\ | ||
- | |An indicator with the post attachment on the back will not fit in the lifter hole vertically. ((photos by Hippysmack))||Steel plate bolted against the gearcase cover for a \\ magnetic base holder and digital indicator. ((photo by Jorgen of the XLFORUM http://xlforum.net/forums/showthread.php?t=761410&highlight=degreeing+cams&page=4))| | + | |An indicator with the post attachment on the back will not fit in the lifter hole vertically. ((photos by Hippysmack))||Steel plate bolted against the gearcase cover for a \\ magnetic base holder and digital indicator. ((photo by Jorgen of the XLFORUM https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-motor-engine/sportster-motorcycle-bottom-end/92792-cam-choices/page4?t=761410&highlight=degreeing+cams&page=4))| |
|{{:techtalk:ref:tools:indicator_mod_for_degreeing_cams_1_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:tools:indicator_mod_for_degreeing_cams_2_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:tools:dial_caliper_by_jorgen.jpg?direct&300|}}| | |{{:techtalk:ref:tools:indicator_mod_for_degreeing_cams_1_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:tools:indicator_mod_for_degreeing_cams_2_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:tools:dial_caliper_by_jorgen.jpg?direct&300|}}| | ||