Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
techtalk:ref:tools142 [2020/06/16 15:54] hippysmack |
techtalk:ref:tools142 [2020/06/16 16:03] hippysmack [Installation] |
||
|---|---|---|---|
| Line 188: | Line 188: | ||
| But without having that tool, a socket was bolted up into the bearing bore sitting on top of the open end of the ring to keep it from popping out. \\ | But without having that tool, a socket was bolted up into the bearing bore sitting on top of the open end of the ring to keep it from popping out. \\ | ||
| Then the other side of the ring was carefully knocked into the bore with a wooden dowel and a hammer. \\ | Then the other side of the ring was carefully knocked into the bore with a wooden dowel and a hammer. \\ | ||
| - | Once the ring was fully in the bore, the socket was used to know the ring down so it snapped into the groove. ((photos by Hippysmack)) \\ | + | Once the ring was fully in the bore, the socket was used to push the ring down so it snapped into the groove. ((photos by Hippysmack)) \\ |
| {{:techtalk:ref:tools:swingarm_bearing_lockring_10_on_1998_xl1200s.jpg?direct&300|}} {{:techtalk:ref:tools:swingarm_bearing_lockring_11_on_1998_xl1200s.jpg?direct&300|}} {{:techtalk:ref:tools:swingarm_bearing_lockring_12_on_1998_xl1200s.jpg?direct&300|}} \\ | {{:techtalk:ref:tools:swingarm_bearing_lockring_10_on_1998_xl1200s.jpg?direct&300|}} {{:techtalk:ref:tools:swingarm_bearing_lockring_11_on_1998_xl1200s.jpg?direct&300|}} {{:techtalk:ref:tools:swingarm_bearing_lockring_12_on_1998_xl1200s.jpg?direct&300|}} \\ | ||
