Differences

This shows you the differences between two versions of the page.

--- techtalk:ref:tools142 [2019/12/02 02:59]
hippysmack [Swingarm Tools]
+++ techtalk:ref:tools142 [2020/06/13 08:20]
hippysmack
@@ Line 5: / Line 5: @@
 ====== Pivot Bolt ======
 -03 swingarm pivot bolt wrench sizes. \\
+To remove the pivot bolt, remove the pivot bolt screw and turn the bolt a few turns to loosen it up. \\
+Put the pivot bolt screw back in a few turns and whack it with a hammer to initially drive it toward the right side. \\
+Then use a screwdriver to pry the bolt out while turning the screw. Continue turning while giving up pressure on the wrench to back the bolt out. \\
 {{:techtalk:ref:tools:pivot_bolt_screw_2925a_wrench_size_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:ref:tools:pivot_bolt_41568-81b_wrench_size_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\
-===== Swingarm Thread Repair Tool =====
+{{:techtalk:ref:tools:pivot_bolt_removal_1_by_hippysmack.jpg?direct&300|}}  ((photo by Hippysmack)) {{:techtalk:ref:tools:pivot_bolt_removal_2_by_hippysmack.jpg?direct&300|}}  ((photo by Hippysmack)) \\
+====== Swingarm Thread Repair Tool ======
 A wrecked right side bearing locknut 47515-52 [52 to E74] with a fitting welded into it. \\ Slots were cut into the threads and it is used to chase / repair the threads in the swingarm. ((IronMick of the XLFORUM http://xlforum.net/forums/showthread.php?t=1532528))

Trace: