Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:ref:tools142 [2019/12/02 03:10] hippysmack [Pivot Bolt] |
techtalk:ref:tools142 [2020/06/13 08:20] hippysmack |
||
|---|---|---|---|
| Line 8: | Line 8: | ||
| Put the pivot bolt screw back in a few turns and whack it with a hammer to initially drive it toward the right side. \\ | Put the pivot bolt screw back in a few turns and whack it with a hammer to initially drive it toward the right side. \\ | ||
| Then use a screwdriver to pry the bolt out while turning the screw. Continue turning while giving up pressure on the wrench to back the bolt out. \\ | Then use a screwdriver to pry the bolt out while turning the screw. Continue turning while giving up pressure on the wrench to back the bolt out. \\ | ||
| - | {{:techtalk:ref:tools:pivot_bolt_screw_2925a_wrench_size_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:ref:tools:pivot_bolt_removal_1_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | + | {{:techtalk:ref:tools:pivot_bolt_screw_2925a_wrench_size_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:ref:tools:pivot_bolt_41568-81b_wrench_size_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ |
| - | {{:techtalk:ref:tools:pivot_bolt_41568-81b_wrench_size_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:ref:tools:pivot_bolt_removal_2_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | + | {{:techtalk:ref:tools:pivot_bolt_removal_1_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:ref:tools:pivot_bolt_removal_2_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ |
| - | ===== Swingarm Thread Repair Tool ===== | + | ====== Swingarm Thread Repair Tool ====== |
| A wrecked right side bearing locknut 47515-52 [52 to E74] with a fitting welded into it. \\ Slots were cut into the threads and it is used to chase / repair the threads in the swingarm. ((IronMick of the XLFORUM http://xlforum.net/forums/showthread.php?t=1532528)) | A wrecked right side bearing locknut 47515-52 [52 to E74] with a fitting welded into it. \\ Slots were cut into the threads and it is used to chase / repair the threads in the swingarm. ((IronMick of the XLFORUM http://xlforum.net/forums/showthread.php?t=1532528)) | ||
