Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:ref:tools142 [2020/06/13 08:20] hippysmack |
techtalk:ref:tools142 [2020/06/13 08:21] hippysmack [Swingarm Thread Repair Tool] |
||
|---|---|---|---|
| Line 11: | Line 11: | ||
| {{:techtalk:ref:tools:pivot_bolt_removal_1_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:ref:tools:pivot_bolt_removal_2_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | {{:techtalk:ref:tools:pivot_bolt_removal_1_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:ref:tools:pivot_bolt_removal_2_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | ||
| - | ====== Swingarm Thread Repair Tool ====== | ||
| - | |||
| - | A wrecked right side bearing locknut 47515-52 [52 to E74] with a fitting welded into it. \\ Slots were cut into the threads and it is used to chase / repair the threads in the swingarm. ((IronMick of the XLFORUM http://xlforum.net/forums/showthread.php?t=1532528)) | ||
| - | |||
| - | |{{:techtalk:ref:tools:swingarmthreads1_by_ironmick.jpg?direct&300|}}|{{:techtalk:ref:tools:swingarmthreads2_by_ironmick.jpg?direct&300|}}| | ||
| - | | Swingarm thread repair tool ((photos by IronMick of the XLFORUM http://xlforum.net/forums/showthread.php?t=1532528)) || | ||
| - | |||
| - | |{{:techtalk:ref:tools:swingarmthreads3_by_ironmick.jpg?direct&300|}}|{{:techtalk:ref:tools:swingarmthreads4_by_ironmick.jpg?direct&300|}}| | ||
| - | | Swingarm thread repair tool ((photos by IronMick of the XLFORUM http://xlforum.net/forums/showthread.php?t=1532528)) || | ||
| \\ | \\ | ||
