Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:ref:tools145 [2018/07/24 18:49] hippysmack [Oil Pump Check Ball Seat Lapping Tool] |
techtalk:ref:tools145 [2019/03/04 22:10] hippysmack [Retaining Rings] |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| ====== REF: Tools - 145 ====== | ====== REF: Tools - 145 ====== | ||
| ====== Oil Pump Tools ====== | ====== Oil Pump Tools ====== | ||
| - | ===== Oil Pump Check Ball Seat Lapping Tool ===== | + | ====== Oil Pump Check Ball Seat Lapping Tool ====== |
| This is used to lap the seat where the check ball sits in the oil pump (57-76). | This is used to lap the seat where the check ball sits in the oil pump (57-76). | ||
| Line 8: | Line 8: | ||
| |Homemade check ball lapping tool made with a tool steel shank and a \\ 3/8" carbide ball tip on the end. The pocket for the ball to sit was cut \\ with a 3/8" ball end mill then a few drops of Loctite 404 to keep it there. ((photo by Toolmaker of the XLFORUM http://xlforum.net/forums/showthread.php?t=499487&highlight=check+ball+lapping+tool))| | |Homemade check ball lapping tool made with a tool steel shank and a \\ 3/8" carbide ball tip on the end. The pocket for the ball to sit was cut \\ with a 3/8" ball end mill then a few drops of Loctite 404 to keep it there. ((photo by Toolmaker of the XLFORUM http://xlforum.net/forums/showthread.php?t=499487&highlight=check+ball+lapping+tool))| | ||
| + | ====== Retaining Rings ====== | ||
| + | These precision cuticle scissors are great for removing external retainer rings. \\ | ||
| + | Especially the ones on oil pumps or anywhere they are hard to reach. \\ | ||
| + | The normal ring pliers are bulky, the end points hardly match the holes and the tool usually slips off the retainer. \\ | ||
| + | These scissors have fine points that won't break or slip on the retainers as the normal ones sometimes do. \\ | ||
| + | You can get the points deeper into the holes which helps to hold the retainer more sturdy while removing it. \\ | ||
| + | These work for removal and installation of the retainer rings. ((photos by Hippysmack)) \\ | ||
| + | |||
| + | |{{:techtalk:ref:tools:precision_cuticle_scissors_1_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:tools:precision_cuticle_scissors_2_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:tools:precision_cuticle_scissors_3_by_hippysmack.jpg?direct&300|}}| | ||
| + | |||
| + | |||
| + | |{{:techtalk:ref:tools:precision_cuticle_scissors_4_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:tools:precision_cuticle_scissors_5_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:tools:precision_cuticle_scissors_6_by_hippysmack.jpg?direct&300|}}| | ||
