Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ref:tools145 [2019/12/20 21:29] hippysmack |
techtalk:ref:tools145 [2019/12/20 21:31] hippysmack [Oil Pump Check Ball Seat Lapping Tool] |
||
---|---|---|---|
Line 24: | Line 24: | ||
You'd probably need a lathe, a tap set and the ability to braze or silver solder to make your own tool. \\ | You'd probably need a lathe, a tap set and the ability to braze or silver solder to make your own tool. \\ | ||
Although you might drill out and tap an un-needed pump nipple for part of the tool. \\ | Although you might drill out and tap an un-needed pump nipple for part of the tool. \\ | ||
+ | You can indicate the bolts in the chuck, face off the ends and then center drill them to provide a concentric pocket for the sphere to rest in. \\ | ||
+ | Then, hold the whole mess in tension between centers as you soldered. They surely have to be straight or they aren’t much use. \\ | ||
|{{:techtalk:ref:tools:homemade_check_ball_lapping_tool_by_toolmaker.jpg?direct&300|}}|{{:techtalk:ref:tools:oil_pump_check_ball_lap_by_dawind.jpg?direct&300|}}| | |{{:techtalk:ref:tools:homemade_check_ball_lapping_tool_by_toolmaker.jpg?direct&300|}}|{{:techtalk:ref:tools:oil_pump_check_ball_lap_by_dawind.jpg?direct&300|}}| |