Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
techtalk:ref:transfinal01a [2023/01/25 07:20] ixl2relax [Installing Chain-to-Belt Conversion] |
techtalk:ref:transfinal01a [2023/01/25 07:33] (current) ixl2relax [Parts] |
||
---|---|---|---|
Line 1: | Line 1: | ||
[[:techtalk:menu|{{ :techtalk:gototechnicalmenu.jpg|}}]] | [[:techtalk:menu|{{ :techtalk:gototechnicalmenu.jpg|}}]] | ||
- | ====== REF: Gears, Sprockets, Belts - 01A ====== | + | ====== REF: Gears, Sprockets, Belts - Sub-01A ====== |
\\ | \\ | ||
====== Installing Chain-to-Belt Conversion ====== | ====== Installing Chain-to-Belt Conversion ====== | ||
Line 13: | Line 13: | ||
===== Parts ===== | ===== Parts ===== | ||
- | I found multiple used rear pulleys on eBay under $50 got a used but perfect 128 tooth belt for $65 got the belt guard for $35. Only bought a new VTwin front pulley for $85.\\ | + | I found multiple used rear pulleys on eBay under $50. I got a used but perfect 128 tooth belt for $65.\\ |
+ | I got the belt guard for $35. Only bought a new VTwin front pulley for $85.\\ | ||
{{:techtalk:ref:transfinal:dave76-cn-blt-03.jpg?400|image1}} | {{:techtalk:ref:transfinal:dave76-cn-blt-03.jpg?400|image1}} | ||
Line 19: | Line 20: | ||
{{:techtalk:ref:transfinal:dave76-cn-blt-04.jpg?400|image1}} | {{:techtalk:ref:transfinal:dave76-cn-blt-04.jpg?400|image1}} | ||
- | A standard 1991 Belt Drive Sprocket Cover will be needed, the left middle bolt is no longer used so I just used a short faux bolt and nut. | + | A standard 1991 Belt Drive Sprocket Cover will be needed. The left middle bolt will not be used so I just placed a short faux bolt and nut there. |
The Belt I used was 1-1/8" wide with 128 teeth. This puts the axle adjuster in the middle of the range. | The Belt I used was 1-1/8" wide with 128 teeth. This puts the axle adjuster in the middle of the range. |