Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
techtalk:evo:susp03a [2020/06/16 23:18] – [Installation] hippysmacktechtalk:evo:susp03a [2020/06/17 02:32] (current) – [Inspecting the Swingarm and Parts] hippysmack
Line 46: Line 46:
  
 Check that the swingarm isn't warped, damaged or rusted. \\ Check that the swingarm isn't warped, damaged or rusted. \\
 +
 +{{:techtalk:evo:susp:swingarm_maintenance_36_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\
 +
  
 Remove the pivot bolt spacer and inspect both the spacer and it's bushing in the left pivot for damage or pitting. \\ Remove the pivot bolt spacer and inspect both the spacer and it's bushing in the left pivot for damage or pitting. \\
Line 56: Line 59:
 Hopefully your bearings won't look as bad as the ones below. You can spray them down with brake cleaner to clean off the old grease. \\ Hopefully your bearings won't look as bad as the ones below. You can spray them down with brake cleaner to clean off the old grease. \\
  
-After cleanup, these bearings sis not roll smooth (bumps felt while turning) so they had to be replaced. \\+After cleanup, these bearings did not roll smooth (bumps felt while turning) so they had to be replaced. \\
  
 {{:techtalk:evo:susp:swingarm_maintenance_19_by_hippysmack.jpg?direct&300|}} {{:techtalk:evo:susp:swingarm_maintenance_20_by_hippysmack.jpg?direct&300|}} {{:techtalk:evo:susp:swingarm_maintenance_19_by_hippysmack.jpg?direct&300|}} {{:techtalk:evo:susp:swingarm_maintenance_20_by_hippysmack.jpg?direct&300|}}

Trace: