Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Last revision Both sides next revision | ||
techtalk:evo:susp03e [2020/06/17 16:00] hippysmack [1998 Style Pivot Bolt] |
techtalk:evo:susp03e [2021/02/02 06:34] hippysmack [Bearing Lockring] |
||
---|---|---|---|
Line 26: | Line 26: | ||
It's actually just a retaining ring acting as both a stop and a spacer between each bearing race when they are installed. \\ | It's actually just a retaining ring acting as both a stop and a spacer between each bearing race when they are installed. \\ | ||
- | Officially, it's a Constant Section Internal Retaining Ring (AKA, Eaton-style or horseshoe snap rings). ((https://www.prospectfastener.com/snaprings/internalrings/constant-section-internal-rings)) \\ | + | Officially, it's a Constant Section Internal Retaining Ring (AKA, Eaton-style or horseshoe snap rings) of the "Bearing Snap Ring" variety. ((https://www.prospectfastener.com/snaprings/internalrings/constant-section-internal-rings)) \\ |
It features a uniform, constant section. This means that the material used to make the ring is the same width at any point along the circumference of the ring. \\ | It features a uniform, constant section. This means that the material used to make the ring is the same width at any point along the circumference of the ring. \\ | ||
This allows full seat of the races against it as they are installed. \\ | This allows full seat of the races against it as they are installed. \\ |