This is an old revision of the document!
IH: Engine Control - Sub-02A
Bench Testing an Ironhead Solenoid
Three tests to bench test the solenoid, text and video … 2)
- Insert a deep socket part way into solenoid.
- Connect battery -ve to the short stud of the solenoid.
- Momentarily apply +12 volt jumper wire to the (thin/small) terminal of the solenoid.
- The socket should pull in.
Leave it pulled in to test the hold-in coil.
To test the hold-in coil:
- Move the battery -ve jumper from the short stud to the solenoid case.
- Apply +12 volts to the (thin/small) terminal and leave it connected.
- Try to pull the socket out of the solenoid.
The hold-in coil should resist your effort to pull the socket out while +12 volts is applied to the (thin/small) terminal. - Remove the +12 volts from the (thin/small) terminal.
The socket should slide easily back out of the solenoid.
To load test the contact plate of the solenoid:
A headlight bulb works well for this.
- Jumper from batt +ve to to +ve of light.
- Jumper from long stud to -ve of light.
- Jumper from batt -ve to short stud.
- Manually push in the plunger.
The bulb should light up.
And here is the YouTube video: Bench Test Solenoid from IronHead Sportster
1)
photo by IronMick of the XLFORUM http://xlforum.net/forums/showthread.php?t=1525907
2)
IronMick of the XLFORUM http://xlforum.net/forums/showthread.php?t=1525907