Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
techtalk:ih:oil02 [2021/02/27 03:13] hippysmack [Transmission / Primary Vent] |
techtalk:ih:oil02 [2022/03/11 07:45] hippysmack [Transmission / Primary Vent] |
||
---|---|---|---|
Line 19: | Line 19: | ||
[[techtalk:ih:oil06#transmission_vent_hose_77-85|Click here]] to diagnose leaks from the vent hose. \\ | [[techtalk:ih:oil06#transmission_vent_hose_77-85|Click here]] to diagnose leaks from the vent hose. \\ | ||
- | 1957-1976 models vent the primary thru the motor internally via the oil transfer valve. [[techtalk:ih:oil01#transfer_valve_76_and_earlier|Click here]] to read more on the transfer valve in the Sportsterpedia. \\ | + | 1957-1976 models vent the primary thru the motor internally via the oil transfer valve. \\ [[techtalk:ih:oil01#transfer_valve_76_and_earlier|Click here]] to read more on the transfer valve in the Sportsterpedia. \\ |
1977-1985 models vent out the back of the motor from the top of the transmission near the rear motor mount just behind the solenoid (1/4” hose fitting). \\ | 1977-1985 models vent out the back of the motor from the top of the transmission near the rear motor mount just behind the solenoid (1/4” hose fitting). \\ | ||
- | * The primary / transmission vents to atmosphere from the top of the transmission near the rear motor mount just in front of the solenoid (1/4" hose fitting). \\ [[techtalk:ih:oil02|Click here]] for more information on the trans/primary vent in the Sportsterpedia. | + | The primary / transmission vents to atmosphere from the top of the transmission near the rear motor mount just in front of the solenoid (1/4" hose fitting). \\ |
===== Routing the Vent Hose ===== | ===== Routing the Vent Hose ===== | ||
- | \\ | + | |
==== 1977-1980 ==== | ==== 1977-1980 ==== | ||
Line 35: | Line 36: | ||
==== 1981-1985 ==== | ==== 1981-1985 ==== | ||
- | * 1981-1985 models use a pressed in metal tube (34744-77) instead with a 1/4" hose nipple on the end. \\ This coincides with a change in starters in 1981. | + | * 1981-1985 models use a pressed in metal tube (26272-81) instead with a 1/4" hose nipple on the end. \\ This coincides with a change in starters in 1981. |
* The 1981 vent nipple is on the top right of the case just under the end of the starter solenoid. | * The 1981 vent nipple is on the top right of the case just under the end of the starter solenoid. | ||
* In 1982, they moved the vent farther in toward the center, still under the solenoid. \\ | * In 1982, they moved the vent farther in toward the center, still under the solenoid. \\ |