Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ref:tools032 [2022/03/27 03:08] hippysmack [Metric Nut/Bolt Threads] |
techtalk:ref:tools032 [2022/03/27 07:01] hippysmack [Measuring Threads In General] |
||
---|---|---|---|
Line 6: | Line 6: | ||
\\ | \\ | ||
====== Measuring Threads In General ====== | ====== Measuring Threads In General ====== | ||
+ | **Thread TPI or Pitch**: \\ | ||
You can purchase a cheap template with different size threads to size screws/bolts or go by your local hardware store to use theirs. \\ | You can purchase a cheap template with different size threads to size screws/bolts or go by your local hardware store to use theirs. \\ | ||
But you don't really need one to accurately find the size of most bolts or thread patterns. \\ | But you don't really need one to accurately find the size of most bolts or thread patterns. \\ | ||
Line 25: | Line 25: | ||
You can buy tap/drill and metric conversion charts pretty cheap online or at some bolt or hardware stores. \\ | You can buy tap/drill and metric conversion charts pretty cheap online or at some bolt or hardware stores. \\ | ||
- | Then hang them up in your shop where you can always find them when needed. \\ | + | Then hang them up in your shop where you can always find them when needed. \\ |
+ | |||
+ | **Bolt/Screw Length**: \\ | ||
+ | Length is measured from the very end of a bolt/screw to where the fastened surface is assumed to be. \\ | ||
+ | Panhead screws / hex bolts / cap screws etc. are measured from under the head to the end. \\ | ||
+ | Flat head screws, tapered shanks under the head, are measured for overall end to end length (head is assumed to end flush with fastened piece). \\ | ||
+ | |||
+ | | Measuring length ((composite of photos used with permission)) | | ||
+ | |{{:techtalk:ref:tools:measuring_different_type_bolts_or_screws.jpg?direct&300|}}| | ||
|SAE thread gauge: ((photos by Hippysmack))||Tap/drill and metric conversion charts.| | |SAE thread gauge: ((photos by Hippysmack))||Tap/drill and metric conversion charts.| |