Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:ref:tools032 [2022/03/27 05:35] hippysmack [Measuring Threads In General] |
techtalk:ref:tools032 [2022/03/27 07:01] hippysmack [Measuring Threads In General] |
||
|---|---|---|---|
| Line 31: | Line 31: | ||
| Panhead screws / hex bolts / cap screws etc. are measured from under the head to the end. \\ | Panhead screws / hex bolts / cap screws etc. are measured from under the head to the end. \\ | ||
| Flat head screws, tapered shanks under the head, are measured for overall end to end length (head is assumed to end flush with fastened piece). \\ | Flat head screws, tapered shanks under the head, are measured for overall end to end length (head is assumed to end flush with fastened piece). \\ | ||
| + | |||
| + | | Measuring length ((composite of photos used with permission)) | | ||
| + | |{{:techtalk:ref:tools:measuring_different_type_bolts_or_screws.jpg?direct&300|}}| | ||
| |SAE thread gauge: ((photos by Hippysmack))||Tap/drill and metric conversion charts.| | |SAE thread gauge: ((photos by Hippysmack))||Tap/drill and metric conversion charts.| | ||
