Table of Contents
This is an old revision of the document!
REF: Shop Notes, Tips, and Tools - Sub-03D
Wrist Pin Removal - Installation Tools
Home made wrist pin removal / installation tool. 5/16“ all thread, 2 fender washers, two nuts, two PVC spacers and two 1/2” sockets. 1) |
---|
The socket should be slightly smaller than the OD of the wrist pin. This can be used to remove and install the wrist pin. 2) | Another one made from a 3/4 inch bolt with two washers and a nut. 3) | 9/16 UNF high tensile bolt with stepped collars turned to fit loosely in the new bush, and slightly smaller than the outside diameter and pulled the old bushes out and the new ones in. Make sure the chamfered end of the bushing goes in first. 4) |
---|
Wrist Pin Bushing Reaming Jig
Rocker Box Tools
1)
, 2)
pics courtesy of humancertainty of the XLFORUM http://xlforum.net/forums/showthread.php?t=1952102&highlight=wrist+pin+removal+tool
3)
photo by arisaka of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=16
4)
photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586
5)
photos by Hippysmack