This is an old revision of the document!


EVO: Carburetor, Intake Manifold & Exhaust

Intake Manifold

Factory Equipped with Keihin Non-CV Carburetor
Year ModelIntake
Manifold
Flanges Intake Seal (2)Carb
Insulating Spacer
FrontRear
86-8727004-86
sold individually
27009-8627010-8626995-86A27003-86
flange upgrade (Late 1986)insulator upgrade (1988)
27009-86A27010-86A27003-86A
flange upgrade (1989)
27009-86B27010-86B
Factory Equipped with Keihin CV Carburetor
Year ModelIntake
Manifold
Flanges Intake Seal (2)Carb Seal
FrontRear
88-8927004-88
rubber intake
sold individually
27009-86A27010-86A26995-86A
w/ insert (2)
29049-88
worm clamp
flange upgrade (1989)
27009-86B27010-86B
90-0327004-88A
aluminum intake (27004-89)
sold as kit with
intake and carb seals
27009-86A27010-86A26995-86Aring seal
27002-89
04-0627024-04
aluminum intake
sold as kit with
(map,seal,clip & screw)
27009-86A27010-86A26995-86Aring seal
27002-89

90-03 Intake Manifold (27004-88A)

Subdocuments


Sold as a kit with intake and carb seals.

Intake casting part number: (27004-89)Shown with flanges.
Front: (27009-86A) Rear: (27010-86A)

Intake Flanges

Flange part numbers Front: (27009-86A) Rear: (27010-86A)

Seals

90-03 Intake Seals

07 and Up Intake Manifold

2007-up (EFI) heads have a wider bolt pattern for the intake flanges. 1)
It's easier to get to the bolts on 07 and up intakes.
All the 2007+ heads have their manifold mating surfaces milled down about 1/16“ as compared with carb type heads.
If you were to try and put the carb type intake manifold on an 07 engine, you'll find it needs to be about 1/8” wider.
If you don't get a wider manifold, there's a good chance you'll have issues with the seals being sucked into the intake ports on decel.


This website uses cookies for visitor traffic analysis. By using the website, you agree with storing the cookies on your computer.More information