Differences

This shows you the differences between two versions of the page.

--- techtalk:evo:elec02b [2019/11/14 00:30]
hippysmack [Loosen the primary chain adjuster]
+++ techtalk:evo:elec02b [2019/11/14 00:31]
hippysmack [Remove the clutch release assembly]
@@ Line 33: / Line 33: @@
 {{:techtalk:evo:priclutch:removing_clutch_ramp_assembly_3_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:evo:priclutch:removing_clutch_ramp_assembly_4_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:evo:priclutch:removing_clutch_ramp_assembly_5_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\
+===== Loosen the primary chain adjuster =====
+Loosening the primary chain adjuster takes the pressure off the primary chain from the cover. \\
+Hold the stud with a 1/4" Allen wrench and use a 7/8" open end wrench to loosen the tightening nut. \\
+Once the nut is loose, unscrew the stud until it bottoms out to loosen the chain adjuster. \
+This is easier done before removing the cover since the engine holds the assembly in place. \\
+If you don't loosen this before re-installing the cover, it will be more difficult to install the cover later. \\
+{{:techtalk:evo:engmech:removing_primary_cover_5_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:evo:engmech:removing_primary_cover_6_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\
 ===== Clutch cable =====

Trace: