Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:ih:carb07 [2021/08/01 21:58] ixl2relax |
techtalk:ih:carb07 [2021/08/03 00:29] ixl2relax [Seals - Intake to Heads] |
||
|---|---|---|---|
| Line 9: | Line 9: | ||
| ===== Seals - Intake to Heads ===== | ===== Seals - Intake to Heads ===== | ||
| - | ^ Intake to Head - Hardware History. ((See Brucstoudt & Dr_Dick - XLForum - http://xlforum.net/forums/showthread.php?t=2079889)) | | + | ^ Intake to Head - Hardware History. ((See Brucstoudt & Dr_Dick - XLForum - http://xlforum.net/forums/showthread.php?t=2079889)) ||| |
| - | | 57-78 had the exact same port sealing machining, heads and manifolds - **They use O-rings**. | | + | | 1957-78 | had the exact same port sealing machining, heads and manifolds | **Uses O-rings**. | |
| - | | 1979 is confusing because it had the o-ring machining but **it used rubber bands**. | | + | | 1979 | is confusing because it had the o-ring machining but | **Uses rubber bands**. | |
| - | | 80-later had the "o-ring delete" machining. **These use the rubber bands**.| | + | | 1980-later | had the "o-ring delete" machining. | **Uses rubber bands**.| |
| - | | | | + | | ||| |
| - | | (If you had a 79 you could retro fit 78-earlier interface mechanisms as a bolt on.) | | + | | 1979 models could retro fit 78-earlier interface mechanisms as a bolt on mod. ||| |
| - | | 80-later needed the heads to be machined if you wanted to go back to the straight up o-ring seals. | | + | | 1980-later models needed the heads to be machined for reverting to the straight up o-ring seals. ||| |
| ===== Bendix ===== | ===== Bendix ===== | ||
