Differences

This shows you the differences between two versions of the page.

--- techtalk:ih:carb07 [2020/04/01 20:08]
hippysmack [IH: Carburetor, Intake Manifold & Exhaust]
+++ techtalk:ih:carb07 [2021/08/03 00:28]
ixl2relax [Seals - Intake to Heads]
@@ Line 1: / Line 1: @@
 [[:techtalk:menu|{{  :techtalk:gototechnicalmenu.jpg|}}]]
-====== IH: Carburetor, Intake Manifold & Exhaust Systems ======
+====== IH: Carburetor, Intake Manifold & Exhaust ======
 See also [[techtalk:ih:engmech03a|Installation of Top End]] for proper alignment of intake manifold.
@@ Line 6: / Line 6: @@
 ====== Intake Manifold ======
+===== Seals - Intake to Heads =====
+^ Intake to Head - Hardware History. ((See Brucstoudt & Dr_Dick - XLForum - http://xlforum.net/forums/showthread.php?t=2079889)) |||
+| 1957-78 | had the exact same port sealing machining, heads and manifolds | **These use the O-rings**. |
+| 1979 | is confusing because it had the o-ring machining but | **These use the rubber bands**. |
+| 1980-later | had the "o-ring delete" machining. | **These use the rubber bands**.|
+| |||
+| 1979 models could retro fit 78-earlier interface mechanisms as a bolt on mod. |||
+| 1980-later models needed the heads to be machined for reverting to the straight up o-ring seals. |||
 ===== Bendix =====
 {{:techtalk:ih:carb:bendix_mounting_hardware_by_the_doctor71.jpg?direct&300|}} ((photo by The Doctor71 of the XLFORUM http://xlforum.net/forums/showthread.php?t=2071371)) \\

Trace: