Table of Contents
This is an old revision of the document!
IH: Carburetor, Intake Manifold & Exhaust
See also Installation of Top End for proper alignment of intake manifold.
Intake Manifold
Seals - Intake to Heads
Intake to Head - Hardware History. 1) | ||
---|---|---|
1957-78 | had the exact same port sealing machining, heads and manifolds | These use the O-rings. |
1979 | is confusing because it had the o-ring machining but | These use the rubber bands. |
1980-later | had the “o-ring delete” machining. | These use the rubber bands. |
1979 models could retro fit 78-earlier interface mechanisms as a bolt on mod. | ||
1980-later models needed the heads to be machined for reverting to the straight up o-ring seals. |
Bendix
Keihin Butterfly
These V-twin clamps (35-0419) work well for stopping intake leaks. The tool to install them is the same as any oiteker clamp pliers. 6)
7) 8)
1)
See Brucstoudt & Dr_Dick - XLForum - http://xlforum.net/forums/showthread.php?t=2079889
2)
, 3)
, 4)
, 5)
photo by The Doctor71 of the XLFORUM http://xlforum.net/forums/showthread.php?t=2071371
6)
66xlch of the XLFORUM http://xlforum.net/forums/showthread.php?t=1079081&page=5
7)
photo by 66xlch of the XLFORUM http://xlforum.net/forums/showthread.php?t=1079081&page=5
8)
photo by DirtyCory of the XLFORUM http://xlforum.net/forums/showthread.php?t=1079081&page=7