Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ih:engctl01a [2018/09/19 12:14] hippysmack |
techtalk:ih:engctl01a [2018/09/19 12:19] hippysmack [Setting /Adjusting Ignition Timing] |
||
---|---|---|---|
Line 78: | Line 78: | ||
* Then repeat the procedure for the rear points. | * Then repeat the procedure for the rear points. | ||
* Both point gaps should have the same gap spacing. | * Both point gaps should have the same gap spacing. | ||
- | ====== Timing ====== | ||
+ | ===== Setting /Adjusting Ignition Timing ===== | ||
+ | ==== Manual Advance Single Point Circuit Breaker ==== | ||
+ | ==== Auto Advance Single Point Circuit Breaker ==== | ||
+ | ==== Manual Advance Dual Point Circuit Breaker ==== | ||
====== Internal Circuit Breaker (71-78) ====== | ====== Internal Circuit Breaker (71-78) ====== | ||
===== Roll Pin ===== | ===== Roll Pin ===== |