The little roll pin sticking out of the inside of the kicker cover acts as a stop pin. The release should rest on the pin when the clutch lever is fully extended and the adjustment of the release rod is slack. Sometimes they will snap off. This could be due to it being a pretty wimpy size pin, and possibly bad clutch adjustment followed by abuse.

Most of the advice on this is probably good for larger size pins and did not work for this situation including:

* Pick = no good
* Heat / pick = no good, it’s jammed.
* Pack with grease and use pressure to push it out = Too mangled, too small.
* Easy out = if I had one that small, I think it would just expand the pin.
* Hardened drywall screw to yank on = screw too big / pin too hard for softer screws.
* Try annealing pin to allow drilling = maybe a jewellers torch setup would be good for this.