Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ih:engmech01a [2018/05/16 21:19] hippysmack [Sprocket Cover Dowel Hole (Case) Repair] |
techtalk:ih:engmech01a [2018/05/16 23:13] hippysmack [Sprocket Cover Dowel Hole (Case) Repair] |
||
---|---|---|---|
Line 26: | Line 26: | ||
| {{:techtalk:ih:engmech:sprocket_cover_dowel_hole_repair_5_by_hopper.jpg?direct&400|}} ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586)) | | | {{:techtalk:ih:engmech:sprocket_cover_dowel_hole_repair_5_by_hopper.jpg?direct&400|}} ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586)) | | ||
+ | |||
+ | * In the final fit up, I made custom dowel pins and fitted them with a small file and some bearing blue so they are tight as tight and wont work loose again. | ||
+ | * I also drilled and tapped that top stud out to 5/16 for more strength and also plan to add a steel angle bracket from the top of the sprocket cover to the two bolts on the top of the gearbox near rear mounts. SOB will not move ever again!! | ||
+ | * I still had to strip the gearbox and replace those bearings that had been welded right next to. | ||
| Using an electric drill (and proceeding very carefully), came up looking like this. ((photos by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586)) || | | Using an electric drill (and proceeding very carefully), came up looking like this. ((photos by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586)) || | ||
|{{:techtalk:ih:engmech:sprocket_cover_dowel_hole_repair_6_by_hopper.jpg?direct&400|}}|{{:techtalk:ih:engmech:sprocket_cover_dowel_hole_repair_7_by_hopper.jpg?direct&400|}}| | |{{:techtalk:ih:engmech:sprocket_cover_dowel_hole_repair_6_by_hopper.jpg?direct&400|}}|{{:techtalk:ih:engmech:sprocket_cover_dowel_hole_repair_7_by_hopper.jpg?direct&400|}}| | ||
+ | |||
+ | |||
\\ | \\ |