Differences

This shows you the differences between two versions of the page.

--- techtalk:ih:engmech01a [2018/05/16 21:19]
hippysmack [Sprocket Cover Dowel Hole (Case) Repair]
+++ techtalk:ih:engmech01a [2018/05/16 23:13]
hippysmack [Sprocket Cover Dowel Hole (Case) Repair]
@@ Line 26: / Line 26: @@
 |  {{:techtalk:ih:engmech:sprocket_cover_dowel_hole_repair_5_by_hopper.jpg?direct&400|}} ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586))  |
+  * In the final fit up, I made custom dowel pins and fitted them with a small file and some bearing blue so they are tight as tight and wont work loose again.
+  * I also drilled and tapped that top stud out to 5/16 for more strength and also plan to add a steel angle bracket from the top of the sprocket cover to the two bolts on the top of the gearbox near rear mounts. SOB will not move ever again!!
+  * I still had to strip the gearbox and replace those bearings that had been welded right next to.
 |  Using an electric drill (and proceeding very carefully), came up looking like this. ((photos by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586))  ||
 |{{:techtalk:ih:engmech:sprocket_cover_dowel_hole_repair_6_by_hopper.jpg?direct&400|}}|{{:techtalk:ih:engmech:sprocket_cover_dowel_hole_repair_7_by_hopper.jpg?direct&400|}}|
 \\

Trace: