Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
techtalk:ih:engmech01a [2018/05/16 21:19]
hippysmack [Sprocket Cover Dowel Hole (Case) Repair]
techtalk:ih:engmech01a [2018/05/16 23:13] (current)
hippysmack [Sprocket Cover Dowel Hole (Case) Repair]
Line 26: Line 26:
  
 |  {{:​techtalk:​ih:​engmech:​sprocket_cover_dowel_hole_repair_5_by_hopper.jpg?​direct&​400|}} ((photo by Hopper of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=395586)) ​ | |  {{:​techtalk:​ih:​engmech:​sprocket_cover_dowel_hole_repair_5_by_hopper.jpg?​direct&​400|}} ((photo by Hopper of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=395586)) ​ |
 +
 +  * In the final fit up, I made custom dowel pins and fitted them with a small file and some bearing blue so they are tight as tight and wont work loose again.
 +  * I also drilled and tapped that top stud out to 5/16 for more strength and also plan to add a steel angle bracket from the top of the sprocket cover to the two bolts on the top of the gearbox near rear mounts. SOB will not move ever again!!
 +  * I still had to strip the gearbox and replace those bearings that had been welded right next to.
  
 |  Using an electric drill (and proceeding very carefully), came up looking like this. ((photos by Hopper of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=395586)) ​ ||  |  Using an electric drill (and proceeding very carefully), came up looking like this. ((photos by Hopper of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=395586)) ​ || 
 |{{:​techtalk:​ih:​engmech:​sprocket_cover_dowel_hole_repair_6_by_hopper.jpg?​direct&​400|}}|{{:​techtalk:​ih:​engmech:​sprocket_cover_dowel_hole_repair_7_by_hopper.jpg?​direct&​400|}}| |{{:​techtalk:​ih:​engmech:​sprocket_cover_dowel_hole_repair_6_by_hopper.jpg?​direct&​400|}}|{{:​techtalk:​ih:​engmech:​sprocket_cover_dowel_hole_repair_7_by_hopper.jpg?​direct&​400|}}|
 +
 +
  
 \\ \\