Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ih:oil03f [2019/12/19 05:26] hippysmack |
techtalk:ih:oil03f [2019/12/20 21:55] hippysmack [Check Spring] |
||
---|---|---|---|
Line 2: | Line 2: | ||
====== IH: Oiling & Lubrication - Sub-03F ====== | ====== IH: Oiling & Lubrication - Sub-03F ====== | ||
====== 57-76 Oil Pump - Individual Parts and Pics ====== | ====== 57-76 Oil Pump - Individual Parts and Pics ====== | ||
+ | |||
+ | ====== Check Ball ====== | ||
+ | |||
+ | Used until mid 1958, the tail of check fits inside the hollow center guide bore of the fitting. ((photo by Dr Dick of the XLFORUM http://xlforum.net/forums/showthread.php?t=1347614&page=2)) \\ | ||
+ | Note that there is no inner face seal surface on the fitting to further isolate the pressure switch port from the 'backside' of the check. \\ | ||
+ | {{:techtalk:ih:oil:oil_pump_check_spring_by_dr_dick.jpg?direct&300|}} {{:techtalk:ih:oil:oil_pump_check_ball_57-58_sportster_by_dr_dick.jpg?direct&300|}} \\ | ||
====== Check Spring ====== | ====== Check Spring ====== |