Table of Contents
This is an old revision of the document!
IH: Oiling & Lubrication - Sub-03F
57-76 Oil Pump - Individual Parts and Pics
Check Spring
There were 3 springs used from 52-76. 1)
(52-56 also used a second valve- pressure relief).
- 52-E57: (26363-36)
- L57-E72: (26364-57)
- L72-76 (26364-72)
This is suppose to be a NOS 67 Pump Spring.
L = 1.215“
Wire Gauge = .024”
67 oil pump spring. 6) |
Breather Gears
(Missing are the -'56 breather gear and long full profile woodruff scavenge drive key and snap-ring). 10)
Breather Gears 11) | Some of amf's signature quality control. These are 3 - 72 breather gears.12) | A closer view13) |
The 2 different breather housings14) | Feed Gear Sets15) | More often than not the solid pin was a slipfit in cross hole.16) |
On to the bodies. The 2nd text is “26217-56a L58-e62”17) | |
The 4 different scavenge gear sets. Lined up from early in foreground to later in background. This is to show the height progression.18) | Top view of all 4 sets.19) | A closer view of the height changes.20) |
1)
Dr Dick of the XLFORUM http://xlforum.net/forums/showthread.php?t=1661356&page=2
2)
, 3)
, 4)
, 5)
The Doctor71 of the XLFORUM of the XLFORUM http://xlforum.net/forums/showthread.php?t=1661356
6)
photo by Monte03 of the XLFORUM http://xlforum.net/forums/showthread.php?t=823881&page=3
7)
photo by Dr Dick of the XLFORUM http://xlforum.net/forums/showthread.php?t=1661356&page=2
8)
photo by fergerburger of the XLFORUM http://xlforum.net/forums/showthread.php?t=1661356
9)
photo by The Doctor71 of the XLFORUM http://xlforum.net/forums/showthread.php?t=1661356
10)
Dr Dick of the XLFORUM http://xlforum.net/forums/showpost.php?p=3272806&postcount=204