Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:ih:oil03f [2019/12/19 05:26] hippysmack |
techtalk:ih:oil03f [2019/12/20 22:13] hippysmack [Check Ball] |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| ====== IH: Oiling & Lubrication - Sub-03F ====== | ====== IH: Oiling & Lubrication - Sub-03F ====== | ||
| ====== 57-76 Oil Pump - Individual Parts and Pics ====== | ====== 57-76 Oil Pump - Individual Parts and Pics ====== | ||
| + | |||
| + | ====== Check Ball ====== | ||
| + | See also [[techtalk:ih:oil03g#check_ball_seat_repair|Check ball seat repair]] in the IH Oil Pump section of the Sportsterpedia. \\ | ||
| + | |||
| + | Used until mid 1958, the tail of check fits inside the hollow center guide bore of the fitting. ((photo by Dr Dick of the XLFORUM http://xlforum.net/forums/showthread.php?t=1347614&page=2)) \\ | ||
| + | Note that there is no inner face seal surface on the fitting to further isolate the pressure switch port from the 'backside' of the check. \\ | ||
| + | {{:techtalk:ih:oil:oil_pump_check_spring_by_dr_dick.jpg?direct&300|}} {{:techtalk:ih:oil:oil_pump_check_ball_57-58_sportster_by_dr_dick.jpg?direct&300|}} \\ | ||
| ====== Check Spring ====== | ====== Check Spring ====== | ||
