Differences

This shows you the differences between two versions of the page.

--- techtalk:ih:oil03f [2019/12/19 05:26]
hippysmack
+++ techtalk:ih:oil03f [2019/12/21 20:23]
hippysmack [Check Ball]
@@ Line 2: / Line 2: @@
 ====== IH: Oiling & Lubrication - Sub-03F ======
 ====== 57-76 Oil Pump - Individual Parts and Pics ======
+====== Oil Check Valve ======
+The oil pump check valve is in the front of the oil pump> It's a spring and a steel ball set up. \\
+The red area in the pic below is the spring & ball sit. \\
+{{:techtalk:ih:oil:57-76_oil_pump_check_valve_location_by_ironheadjunkie_annotated_by_hippysmack.jpg?direct&300|}} ((photo by ironheadjunkie of the XLFORUM http://xlforum.net/forums/showthread.php?t=1490437)) \\
+===== Check Ball =====
+See also [[techtalk:ih:oil03g#check_ball_seat_repair|Check ball seat repair]] in the IH Oil Pump section of the Sportsterpedia. \\
+Used until mid 1958, the tail of check fits inside the hollow center guide bore of the fitting. ((photo by Dr Dick of the XLFORUM http://xlforum.net/forums/showthread.php?t=1347614&page=2)) \\
+Note that there is no inner face seal surface on the fitting to further isolate the pressure switch port from the 'backside' of the check. \\
+{{:techtalk:ih:oil:oil_pump_check_spring_by_dr_dick.jpg?direct&300|}} {{:techtalk:ih:oil:oil_pump_check_ball_57-58_sportster_by_dr_dick.jpg?direct&300|}} \\
 ====== Check Spring ======

Trace: