Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
techtalk:ref:engmech01h [2019/08/17 17:36] hippysmack [Cam Lobes] |
techtalk:ref:engmech01h [2020/08/24 01:58] hippysmack [Test Fitting] |
||
---|---|---|---|
Line 102: | Line 102: | ||
Use a fair amount of assembly lube in the bushings and in the gear teeth. \\ | Use a fair amount of assembly lube in the bushings and in the gear teeth. \\ | ||
Rotate them by hand and make sure they all spin freely without binding. \\ | Rotate them by hand and make sure they all spin freely without binding. \\ | ||
+ | Then, install all 4 cams in the cam cover and make sure they spin freely without binding. \\ | ||
+ | On 2003 and earlier motors, the cams can be rotated thru the nosecone ignition cover. 2004-up covers don't have this hole. \\ | ||
+ | However, several folks have ran 2000-2003 covers on 3004-up motors with no issues. ((NRHS Sales of the XLFORUM http://xlforum.net/forums/showthread.php?t=1756724&page=23)) \\ | ||
- | Then, install all 4 cams in the cam cover and make sure they spin freely without binding. | + | | Test fitting cams in the cam cover ((photo by aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?t=1715966&page=3)) |Test fitting cams with the cam cover installed ((photo by aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?t=1840595))| |
+ | |{{:techtalk:ref:engmech:test_fit_cams_in_cam_cover_by_aswracing.jpg?direct&300|}}|{{:techtalk:ref:engmech:test_fitting_cams_with_the_cam_cover_on_by_aswracing.jpg?direct&300|}}| | ||
- | |{{:techtalk:ref:engmech:test_fit_cams_in_cam_cover_by_aswracing.jpg?direct&300|}}| | ||
- | | Test fitting cams in the cam cover ((photo by aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?t=1715966&page=3)) | | ||
- | |||
- | |{{:techtalk:ref:engmech:test_fitting_cams_with_the_cam_cover_on_by_aswracing.jpg?direct&300|}}| | ||
- | |Test fitting cams with the cam cover installed ((photo by aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?t=1840595))| | ||