Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ref:engmech05f [2019/07/12 23:13] hippysmack [Installing a Buell Rocker Box / Breather System on an Evo Sportster] |
techtalk:ref:engmech05f [2019/07/17 05:30] hippysmack [REF: Oiling & Lubrication - Sub-05B] |
||
---|---|---|---|
Line 1: | Line 1: | ||
[[:techtalk:menu|{{ :techtalk:gototechnicalmenu.jpg|}}]] | [[:techtalk:menu|{{ :techtalk:gototechnicalmenu.jpg|}}]] | ||
- | ====== REF: Oiling & Lubrication - Sub-05B ====== | + | ====== REF: Engine Mechanicals - Sub-05F ====== |
====== Installing a Buell Rocker Box / Breather System on an Evo Sportster ====== | ====== Installing a Buell Rocker Box / Breather System on an Evo Sportster ====== | ||
|Buell XB rocker boxes. ((photos by rubine of the XLFORUM http://xlforum.net/forums/showthread.php?t=42202&highlight=buell&page=4))| | |Buell XB rocker boxes. ((photos by rubine of the XLFORUM http://xlforum.net/forums/showthread.php?t=42202&highlight=buell&page=4))| | ||
- | |{{:techtalk:ref:oil:buell_xb_rocker_boxes-breathers_by_rubine.jpg?direct&300|}}| | + | |{{techtalk:ref:engmech:buell_xb_rocker_boxes-breathers_by_rubine.jpg?direct&300|}}| |
In the pics below, Buell rocker boxes were installed on a 1200R with XB heads using the Buell style rocker box PCV valves. | In the pics below, Buell rocker boxes were installed on a 1200R with XB heads using the Buell style rocker box PCV valves. | ||
Line 12: | Line 12: | ||
|Both PCV valves are connected to a ‘Y’ connector that runs along the frame under the tank. ((photos by mick42 of the XLFORUM http://xlforum.net/forums/showthread.php?p=5762210#post5762210)) The tube \\ comes down into a catch can that can be emptied when it gets too much oil in it. On a long hard ride the \\ catch can will clean its self out. || | |Both PCV valves are connected to a ‘Y’ connector that runs along the frame under the tank. ((photos by mick42 of the XLFORUM http://xlforum.net/forums/showthread.php?p=5762210#post5762210)) The tube \\ comes down into a catch can that can be emptied when it gets too much oil in it. On a long hard ride the \\ catch can will clean its self out. || | ||
- | |{{:techtalk:ref:oil:buell_rocker_box_and_breather_on_a_sporty_1_by_mick42.jpg?direct&300|}}| {{:techtalk:ref:oil:buell_rocker_box_and_breather_on_a_sporty_2_by_mick42.jpg?direct&300|}}| | + | |{{techtalk:ref:engmech:buell_rocker_box_and_breather_on_a_sporty_1_by_mick42.jpg?direct&300|}}| {{techtalk:ref:engmech:buell_rocker_box_and_breather_on_a_sporty_2_by_mick42.jpg?direct&300|}}| |
The tube from the catch can runs up under the fender and exits at the rear on the left side of the bike. \\ | The tube from the catch can runs up under the fender and exits at the rear on the left side of the bike. \\ | ||
Line 18: | Line 18: | ||
If some oil drips from the end, it’s not near the tire and there is no oily mist spraying over all the bike while riding. \\ | If some oil drips from the end, it’s not near the tire and there is no oily mist spraying over all the bike while riding. \\ | ||
|Oil from catch can on left side under fender. ((photo by mick42 of the XLFORUM http://xlforum.net/forums/showthread.php?p=5762210#post5762210))| | |Oil from catch can on left side under fender. ((photo by mick42 of the XLFORUM http://xlforum.net/forums/showthread.php?p=5762210#post5762210))| | ||
- | |{{:techtalk:ref:oil:buell_rocker_box_and_breather_on_a_sporty_3_by_mick42.jpg?direct&250|}}| | + | |{{techtalk:ref:engmech:buell_rocker_box_and_breather_on_a_sporty_3_by_mick42.jpg?direct&250|}}| |