This is an old revision of the document!


REF: Tools - Sub-002

Piston

Piston Rings

Ring Compressor

A wooden spacer with slot to hold piston steady as you slide the cylinders on. Also, a Volkswagen “krinkle cut” ring compressor that comes
apart after the cylinder is on. The crinkle cuts stop it from jamming up in between the piston and cylinder. Also, use plenty of oil in the rings,
piston and cylinder to help it all slide on. 1)
Cylinder Installing Jig 2)

Wrist Pin

Wrist Pin Removal - Installation Tools

Home made wrist pin removal / installation tool. 5/16“ all thread, 2 fender washers, two nuts, two PVC spacers and two 1/2” sockets. 3)
The socket should be slightly smaller than the OD
of the wrist pin. This can be used to remove and
install the wrist pin. 4)
Another one made from a 3/4 inch bolt with
two washers and a nut. 5)
9/16 UNF high tensile bolt with stepped collars
turned to fit loosely in the new bush, and slightly
smaller than the outside diameter and pulled the
old bushes out and the new ones in. Make sure
the chamfered end of the bushing goes in first. 6)

Wrist Pin Bushing Reaming Jig

A couple bits of timber and four bolts.
Holds them nice an steady for reaming. 7)
Two holes in a rag with some tape stops any bronze
chips from getting down in the crankcase. 8)

Wrist Pin Alignment

Check to see if the pin is parallel to the crankcase mouth by using two
pieces of 3/4“ precision key steel from your local bearing supply shop. 9)

Connecting Rod

Balancing

Jig for Balancing Rods 10)


This website uses cookies for visitor traffic analysis. By using the website, you agree with storing the cookies on your computer.More information