Table of Contents
This is an old revision of the document!
REF: Tools - 145
Oil Pump Tools
Oil Pump Check Ball Seat Lapping Tool
This is used to lap the seat where the check ball sits in the oil pump.
Homemade check ball lapping tool made with a tool steel shank and a 3/8“ carbide ball tip on the end. The pocket for the ball to sit was cut with a 3/8” ball end mill then a few drops of Loctite 404 to keep it there. 1) |
1)
photo by Toolmaker of the XLFORUM http://xlforum.net/forums/showthread.php?t=499487&highlight=check+ball+lapping+tool