Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
techtalk:ref:tools023 [2020/05/20 05:10] hippysmack ↷ Links adapted because of a move operation |
techtalk:ref:tools023 [2022/01/18 01:50] hippysmack [Using taps / dies to chase debris out of the threads] |
||
---|---|---|---|
Line 47: | Line 47: | ||
And chasing them with standard size taps / dies simply widens that clearance to standard sizes. \\ | And chasing them with standard size taps / dies simply widens that clearance to standard sizes. \\ | ||
- | **Standard tap and dies** have sharp cutting edges. \\ | + | **Standard tap and dies** have sharp cutting edges. \\\ |
- | If the threads have not been warped or damaged; \\ | + | If the threads have not been warped or damaged, a die will cut through and remove sealants on bolt threads. \\ |
- | A die will cut through and remove sealants on bolt threads. \\ | + | Likewise, a tap will cut through and remove grime and dried up sealants in the existing threads. \\ |
- | Likewise, a tap will cut through and remove sealants on hole threads. \\ | + | There are some holes, however, that are purposely tapped undersize at the factory. \\ |
+ | Running a standard tap in those holes opens the holes up. \\ | ||
+ | (also the low quality taps from the do-it-yourself store are not held to the cutting tolerance that real ground thread H or L limit taps possess) \\ | ||
+ | |||
+ | * Some factory undersize tapped holes on 1957-1976 motors: ((Dr Dick of the XLFORUM http://xlforum.net/forums/showthread.php?t=1888378&page=6)) | ||
+ | * Oil pump studs | ||
+ | * Cylinder base studs | ||
+ | * Rear motor mount studs | ||
+ | * Tool box stud | ||
**Roll form tap and dies** have rounded cutting edges. \\ | **Roll form tap and dies** have rounded cutting edges. \\ | ||
Line 70: | Line 78: | ||
* You can send a pin needle or the like down to the bottom of the hole to see if there is any embedded crap at the bottom. ((ReddTigger from the XLFORUM [[http://xlforum.net/forums/showthread.php?postid=5373930#post5373930]])) | * You can send a pin needle or the like down to the bottom of the hole to see if there is any embedded crap at the bottom. ((ReddTigger from the XLFORUM [[http://xlforum.net/forums/showthread.php?postid=5373930#post5373930]])) | ||
+ | | Chasing cam cover threads. ((photo by AnaChris of the XLFORUM http://xlforum.net/forums/showthread.php?t=1725973&highlight=oil+pump&page=11)) | | ||
+ | |{{:techtalk:ref:tools:chasing_threads_by_anachris.jpg?direct&300|}}| | ||
===== Thread File ===== | ===== Thread File ===== | ||
* This tool is a cross between a tap, a die and a file. | * This tool is a cross between a tap, a die and a file. |